Written by
| Powered by phpBay Pro |
i'm needing help on what amplifier i would need for 4 10' whip audio voice speakers?
the specs on them is:
10" cloth edge paper cone bullet midrange
Die cast aluminum frame
1.5" high temperature aluminum voice coil
50.00 oz magnet structure weight
Bumped yoke plate for extended excursion
vented motor structure
200 watts RMS
400 watts peak
Frequency response 50 hz-6kHz
sensitivity 102 db
8 ohms impedense
I would like them to scream! I had in mind using a 4 channel amp, but am thinkinf of a 2 channel with good rms...Thanks!!
http://cgi.ebay.com/10-whip-audio-car-voice-speakers-new_W0QQitemZ190138145605QQihZ009QQcategoryZ3292QQrdZ1QQssPageNameZWD1VQQcmdZViewItem
What do you think about the Kicker KX850.4? Is it to much?
this is only for treble? if so you should get a 4/3/2 channel eclipse amp. you would need only 75 watts by 4 channel then you can bridge them down to two channels. make sure it has a built in crossover so you can filter out all the bass. if you cant find eclipse try Rockford fosgate, pheniox gold, or clarion. stay away from sony xplode, jbl- they over rate their amps on the wattage.
| Powered by phpBay Pro |
