Written by
| Powered by phpBay Pro |
can i run 4x8 ohm 200w speakers off of a bridged amp?
amp is as follows
the t.amp E-800 stereo amplifier - output power: 2x 440W into 4 Ohms, 2x 240W into 8 ohms (@1kHz, THD<=0.1%). Bridged mode: 1x 800W into 8 Ohms (please check cable configuration for bridged on rear of unit). Frequency response: 10Hz-20kHz; damping factor: >120; inputs: XLR and TRS jack (balanced); outputs: Speakon; DC, short circuit, temperature and limiter protection. Power Supply: 230V~50Hz. 19"/2U rack. Dimensions (WxDxH): 482 x 341.5 x 88mm, 19", 2U
please help guys and i presume ill have to link in series
can i use it with the speakon cable correctly changed to 1+ and 2+ then connect the rest of the speakers by daisy chaining them
reason im asking as my channel b is not working but bridge mode works ok
You must put 2 speakers in series the other 2 in series too and then these 2 groups in parallel!This way the final impedance will be 8ohms!!!
| Powered by phpBay Pro |
